CIRCLE MACHINE(1), Free energy, darmowa energia, perpetuum mobile, HHO, ect, Radionics, Orgone & Psionics CD2, ...
[ Pobierz całość w formacie PDF ]
CIRCLE MACHINE
- a more complex transmitter
To make this instrument you will need:
1 cardboard box
3 potentiometers (value unimportant
wire (guage unimportant but workable)
18 small, ceramic magnets (usually found at Radio Shack)
3 knobs
a piece of aluminum foil
1 plastic can lid
1. Print out the gif of plate 1.
2. Glue that to the top of the cardboard box.
3. Punch holes for the stems of the potentiometers at the center points of the three calibrated
circles at the base of the pattern.
4. Punch two small holes at the edge of the large circle, where the lines from the calibrated
circles meet it.
5. Wire the three potentiometers to each other like the three circles.
6. Attach a longer wire at each end of the series of potentiometers.
7. Attach the potentiometers to the bottom of the box top so that the stems stick out through the
calibrated circles.
8. Put the end of each longer wire through the holes in the box top and lay them in the large
cirlce.
9. Cut out a circle of aluminum foil and glue it to the center of the large circle so that it contacts
the two wires.
10. Glue a magnet to each of the smaller outlying cirles around the larger one.
11. Attach the knobs to the potentiometer stems.
To use this instrument:
1. Place the witness of the target in the center of the foil circle.
2. Tune the instrument for the rate for the target by laying the plastic cover next to the instrument
and gently rubbing it with your thumb while turning each knob. When you get a stick (and you
will know it when you get it) that knob is properly tuned and you repeat the procedure with each
knob until all three are tuned.
3. Gaze intently at the witness and think what you wish to send to the target. The combination of
tuning and the magnetic vortex will significantly amplify your telepathic sendings.
[ Pobierz całość w formacie PDF ]